Extreme Networks Summit X150 Series, Hardware Installation Manual

Page: 269 / 512

Installing Summit 450 W and 550 W Power Supplies
Summit Family Switches Hardware Installation Guide
269
Preparing the Cables
Three spade-type terminals are provided with the power supply. You need a crimping tool to attach the
terminals to the power and ground cables.
To prepare the cables:
1 On each wire, strip 0.25 inch of insulation from one end.
2 Insert the stripped wire end all the way into the barrel of the terminal ( Figure 214 ) and crimp the
terminal securely to the wire.
Figure 214: Attaching a Terminal to a Cable
Installing the Power Supply
To install a 450 W or 550 W DC power supply:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
2 If you are installing the power supply in a Summit X670 series switch:
a Verify that the switch chassis has been grounded (see step 6 on page 293 ).
b Verify that the airflow direction for the power supply is the same as the airflow direction of the
installed fan modules in the switch.
3 If necessary, remove a blank panel from the back of the Summit X480 or X670 series switch
(
Figure 215 ).
Figure 215: Removing a Blank Panel
SH_109
SH