Extreme Networks Summit X150 Series, Hardware Installation Manual

Page: 282 / 512

Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
282
Installing an 850 W AC Power Supply in a Summit X650 Series
Switch
CAUTION
Make sure that the AC power supply circuit is not overloaded. Use proper over-current protection, such as
a circuit-breaker, to prevent over-current conditions.
To install an 850 W AC power supply in a Summit X650 series switch:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
grounding point.
2 If necessary, remove a blank panel from the back of the Summit X650 series switch ( Figure 230 ).
Figure 230: Removing a Blank Panel
3
Verify that the power supply is right side up, with the latching tab at the right of the unit (see
Figure 231 ).
4 Carefully slide the power supply all the way into the power supply bay (see Figure 231 ). Push the
power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
SH_088