Extreme Networks Summit X150 Series, Hardware Installation Manual

Page: 366 / 512

Chapter 10: Replacing DC Power Supplies in Summit Family Switches
Summit Family Switches Hardware Installation Guide
366
To connect the DC power cables to the Summit 450 W DC power supply:
1 Verify that the DC circuit is de-energized.
2 Connect the DC power input cables as follows:
a On each terminal, loosen the screw enough to allow the spade terminal to slide underneath the
captive square washer (
Figure 314 ).
b Slide the spade terminal of the negative wire (–48 V) under the captive square washer on the
negative
terminal (labeled
–
).
c Slide the spade terminal of the positive wire (–48 V RTN) under the captive square washer on the
positive terminal (labeled + ).
Figure 309: Connecting the DC Power Cables (Part 1)
d Tighten both screws on the terminal block to 7 inch-pounds (0.99 Newton meters) ( Figure 310 ).
SH_161
(+)
(–)
RTN
-48V