❏
Other devices on the network are turned on.
❏
Network addresses (IP address, subnet mask, and default gateway) are correct if you have set the printer’s
Obtain IP Address to Manual.
Reset the network address if they are incorrect. You can check the IP address, subnet mask, and default gateway
from the
Network Status
part on the network connection report.
Related Information
&
“Network Settings” on page 191
E-11
Solutions:
Check the following.
❏
The default gateway address is correct if you set the printer’s TCP/IP Setup setting to Manual.
❏
The device that is set as the default gateway is turned on.
Set the correct default gateway address. You can check the default gateway address from the
Network Status
part
on the network connection report.
Related Information
&
“Network Settings” on page 191
E-12
Solutions:
Check the following.
❏
Other devices on the network are turned on.
❏
The network addresses (IP address, subnet mask, and default gateway) are correct if you are entering them
manually.
❏
The network addresses for other devices (subnet mask and default gateway) are the same.
❏
The IP address does not conflict with other devices.
If still does not connect your printer and network devices after confirming the above, try the following.
❏
Turn off the router. Wait for about 10 seconds, and then turn it on.
❏
Make network settings again using the installer. You can run it from the following website.
>
Setup
Related Information
&
“Network Settings” on page 191
&
“Making Settings for Connecting to the Computer” on page 137
Adding or Replacing the Computer or Devices
>
Checking the Network Connection Status
>
141