Electronics Line iconnect, Installation Manual

Page: 117 / 140

Appendix B: Transmitter Installation
iConnect Installation Manual
113
Outdoor Siren and Strobe (EL-4726T)
The EL-4726T is a 2-Way Wireless Outdoor Siren Strobe for use with the iConnect Control System. In the event of an
alarm the control system activates the siren and strobe. The Wireless Siren is sounded until the end of the control-system-
programmed siren cutoff. After the siren cutoff has expired, the strobe continues to flash until the system is disarmed.
Location of Siren Strobe
Consider the following before mounting the siren strobe:
• Choose a suitable mounting location for the siren strobe.
• The siren strobe should be mounted on a flat surface in a highly visible position for maximum deterrence
against potential intruders.
• Before permanently mounting the siren strobe, test the reception from the exact mounting position.
Always wear ear protectors when installing indoor/outdoor sirens
Registration Procedures
The EL-4726T must identify itself to the iConnect Control System as follows:
1.
Set the system to registration mode.
• Go to the main menu and select [9]>[1]>[5]>[1] (Programming > Devices > Siren>WL Siren)
• Select a siren from the list (1-4) and press ' √ʹ.
2. Open the screw cover by applying thumb pressure on the screw cover lower part.
3. Open the cover screw and lift the front cover away from the rear housing.
4. Open the battery housing cover
5. Insert the batteries while paying attention to polarity.
Figure B- 55: Inserting the batteries
6.
The siren will send a transmission. If the transmission is successfully received by the system it will play a
confirmation sound. If no confirmation sound is heard send another transmission by pressing and releasing
the tamper switch of the siren.
7. As soon as 'Save?' appears press ' √ʹ.
Installation Procedure
After the siren strobe has been registered mount the unit as follows:
1.
Place the back cover in position against the wall and mark the upper and lower mounting holes.
2. Install wall anchors in the appropriate positions.
3. Attach the back cover to the wall using supplied screws.
4. Mount the siren strobe to the mounting bracket.
5. Close the battery housing cover and replace the front cover. Pay attention to the tamper switch.
6. Secure the cover screw and replace the screw cover.