10 Communications
iConnect Installation Manual
58
To program the Two-Way Audio option for a Voice Report Account:
1.
From the Programming menu, select Communications, Accounts [951].
2.
Select the account you want to program (2-6).
3.
From the account’s sub-menu, select Two-Way Audio [#4].
4.
Select Enabled or Disabled.
10.3.5.
Home ID
The Home ID is a short message that is played at the beginning of a vocal message call in order to identify the system to
the user. For example, at the beginning of the vocal message call, the message "Michael’s House" will be played before
the event messages.
To play back the Home ID message:
•
From the Programming menu, select Communications, Accounts, Home ID, Play Message [95181].
To record a Home ID message:
1.
From the Programming menu, select Communications, Accounts, Home ID, Record Message [95182].
2.
Press '
√ʹ to start recording the message.
3.
Record your message. The message may be up to ten seconds long.
4.
Press '
√ʹ to stop recording; the m
essage is automatically played back and OK? is displayed. Press '
√ʹ to save your
recording.
10.4.
Remote Programming
Electronics Line 3000’s Remote Programmer (RP) and WEB Remote Programmer software enable you to operate and
program the system from a PC either on-site or from a remote location. The software provides a comprehensive
interface to the iConnect Control System designed to facilitate programming. There are 3 access levels available:
Supervisor (full access), Technician (limited access to the program, a technician is not able to view or change user codes
or the RP access code), and Operator (access to user operations, such as arming and disarming the system).
10.4.1.
Remote Programmer
PC to Control System Connection Methods
You can connect to the Control System from a PC using one of three methods:
•
Direct Call: The RP calls the site, the system picks up and RP communication is established.
•
Callback: The RP calls the site, the system picks up then hangs up. The system then calls the Callback
telephone number to establish a connection.
•
Serial Connection: The RP connects directly via the USB port on the communication module (this method
requires installation of the Control System USB Driver).
The following programming options relate to the method in which the Remote Programmer software connects with the
system.
Callback Telephone Number
RP Callback is a security feature that helps ensure that remote programming is only performed by authorized
personnel. When the Remote Programmer contacts the Control System, the Control System hangs up and calls the
Callback telephone number.
To edit the Callback telephone number:
1.
From the Programming menu, select Communications, Remote Prog., Call-Back # [9521].
2.
Enter up to 16 digits. Use the key to enter "
", "#", "," (pause), "T" (switch to DTMF tone dialing), "P" (switch to
pulse dialing) or "+" (international code). Use the key to delete one character at a time. Press '
√ʹ when you
have finished editing.
If there is no Callback telephone number programmed, RP Callback is disabled and the
system connects to the Remote Programmer software using the "direct call" method.
Summary of Contents for iconnect
