Electronics Line iconnect, Installation Manual

Page: 122 / 140

Appendix B: Transmitter Installation
iConnect Installation Manual
118
Caution
The circuit board is designed to work with all approved 12VDC,7Ah sealed lead batteries as
a backup for the primary power supply in time of main power failure.
The circuit board is designed with reverse polarity protection on the battery charging
circuit. However, prolonged improper connection of the battery to the circuit board will
result in damage.
The battery is not supplied with the 2-Way Wireless I/O Expander Module.
The rechargeable battery should be charged for at least 72 hours.
Battery presence is checked every 10 seconds.
There is a risk of explosion if a battery is replaced with an incorrect type.
Dispose of used batteries according to the proper instructions.
Battery in product shall be replaced every 3-5 years. No maintenance is needed.
The power should remain disconnected until all connections have been made and checked
for accuracy.
Completing the Installation
To complete the installation:
1.
Mount the 2-Way Wireless I/O Expander Module back panel to the wall using affixing screws.
2. Connect the 2-Way Wireless I/O Expander Module to the AC mains power.
Caution
When the circuit board is powered on, mains voltage is present on the main PCB.
To prevent risk of electric shock, disconnect all power (AC transformer and battery) before
servicing.
Under no circumstances should mains power be connected to the PCB other than through
the main terminal block.
A readily accessible disconnection device shall be incorporated in the building installation
wiring.
For continued protection against risk of fire, replace fuses only with fuses of the same type
and rating.
3. Before closing the front cover and securing the locking screw, proceed to Registering the 2-Way Wireless I/O
Expander Module, below.
Registering the I/O Expander Module
The 2-Way Wireless I/O Expander Module must identify itself to the iConnect Control System as follows:
1.
Set the control system to registration mode.
• Go to the main menu and select [9]>[1]>[6] (Programming > Devices > Zone Expanders)
• Select a 2-Way Wireless I/O Expander Module from the list (1-2) and press ' √ʹ.
2. With the plastic unit cover open send a transmission by pressing and releasing the tamper switch of the Wireless
I/O Expander Module. The 2-Way Wireless I/O Expander Module will send a transmission to the control
system. If the transmission is successfully received by the control system it will play a confirmation sound.
3. As soon as 'Save?' appears press ' √ʹ.
4. Close the 2-Way Wireless I/O Expander Module front cover and secure the locking screw.