Electronics Line iconnect, Installation Manual

Page: 106 / 140

Appendix B: Transmitter Installation
iConnect Installation Manual
102
Registration Procedure
The EL-4727 keypad must identify itself to the system receiver. This is done by registering the keypad to the iConnect
Control System as follows:
1.
Release the mounting bracket.
2. Open the battery compartment and insert the batteries. Pay attention to the correct polarity.
3. Set the system to registration mode
• Go to the main menu and select [9]>[1]>[3] (Programming > Devices > Keypads)
• Select a keypad (1-4)
4. Press the keypad's tamper switch.
5. As soon as 'Save?' appears on the Control System’s LCD screen, press ' √ʹ
Installation Procedure
After the keypad has been registered to the system mount the keypad on the wall using the supplied mounting bracket.
1. Before mounting the keypad test the keypad communication with the system. To do so,
try to arm the system using one of the arming buttons on the wireless keypad.
2. Minimum mounting distance between the wireless keypad and the panel is 1.5m.
To mount the keypad:
1.
Release the mounting bracket
2. Attach the mounting bracket to the wall using the supplied screws.
3. Attach the wireless keypad to the mounting bracket by sliding it down.
4. If required attach the housing screw at the bottom of the front cover.
Deleting a Keypad
To delete a wireless keypad from the system:
1.
Set the system to Delete mode.
• Go to the main menu and select [9]>[1]>[3] (Programming > Devices > Keypads).
• Select keypad (1-4) > '
√ʹ
2. Press >'
√ʹ.
3. Take out the keypad batteries.
4. While the back tamper switch is being pressed insert the batteries.
5. Within five seconds open the tamper and close it once again
Replacing Batteries
When the battery needs to be replaced the yellow OK LED will flash.
To replace the battery:
1.
Remove the keypad from the wall.
2. Open the battery compartment.
3. Pull out the battery and replace it with a new one. Pay attention to the polarity when inserting the new batteries
4. Close the battery compartment, and place the keypad back to its place
Gas Leak Detector (EL-4762)
The EL-4762 is a 2-Way Wireless Gas Leak Detector used to detect mixtures of air and combustible gases (Natural Gas,
Methane, Propane and Butane). Upon detecting the presence of gas, the unit emits an alarm and notifies the control panel.