Electronics Line iconnect, Installation Manual

Page: 6 / 140

1 Introduction
iConnect Installation Manual
2
1.2. Specifications
General
Zones: 32 wireless zones, 2 hardwire zones (Zone 33-34), or zones 1 –
8 as wired zones, zones 9 – 32 as wireless and 2 hardwire zone (Zone
33, 34).
Wireless Keyfobs: 19 (Controlled or Non-controlled)
Wireless Keypads: up to 4
Wireless
Repeaters: up to 4
Smartkeys: 12 (Controlled or Non-controlled)
Wireless I/O Zone Expanders: 2
Wireless
Siren
: up to 4
Wired Siren: 1
User Codes: 32
Arming Methods: Full, Part or Perimeter
Event Log: 1022 event capacity, time and date stamped
Weight: 1.350g
Dimensions: 270 x 222 x 50mm
Communications
Event Reporting Accounts: up to 6, including Central Station, Follow-
Me, and Voice
Telephone Numbers: 6 event reporting accounts, RP Callback,
Service Call
Communication Interface Options: GPRS/Ethernet or Ethernet/PSTN
Home Automation
Control Medium: Power-line carrier
Protocol: X10
HA Units: 16 individually addressed
Receiver
Type: Super-heterodyne, fixed frequency
Frequency: 868MHz, 433MHz (optional)
Data Encryption:
SecuriCode™
Electrical*
Power Input: 230VAC, 50Hz
AC Current Consumption (GPRS Configuration): 30mA (alarm),
17mA (standby)
AC Current Consumption (Ethernet Configuration): 35mA (alarm),
17mA (standby)
DC Current Consumption (GPRS Configuration): 280mA (alarm),
130mA (standby)
DC Current Consumption (Ethernet Configuration): 330mA (alarm),
135mA (standby)
Maximum Auxiliary Output Current Rating : 50mA
Battery low: below 7.15V
Backup Battery Pack: 1 x 7.2V/1.8Ah Part No. BT5780
(6 x 1.2V Ni-MH rechargeable cells, size AA)
The maximum charging current for the BT-5780 is 5.4A
For EN-50131 standard, 1.5Ah battery is mandatory
Fuse Ratings: 63mA/250V for 230VAC – Part No. EF1063,
PGM Relay Output Contact Rating: 100mA (max. load)
Built-in Siren: 93dB @ 10ft
Tamper Switch: N.C.
Operating Temperature: 0-60°C /32-140°F
Complies with EN-50131-3 Grade 2 Class II
Power Supply Type A
*
*
The measurements are with fully charged battery. AC current was measured on fuse F1 and DC current was measured on fuse F2.
Power connection to the unit should be according to the national electrical code for permanent installation.
The power supply should be fed from a readily accessible disconnect device.
If the unit is permanently wired to the mains power, use a 2-pole disconnect device (15A max.) and the wires should be min.
0.75mm
2
in a conduit of at least 16mm.
If the mains power is connected with a plug, the plug should be indicated as the disconnecting device and the socket shall be
max. 2m from the Control System.
Batteries shall be provided by a distributor and replaced by authorized service personnel.
The backup battery pack should be replaced every five years.
Batteries should be stored in a cool, dry place.