2 System Installation
iConnect Installation Manual
10
2.2.5.
Step 4 – Testing the Chosen Mounting Location
Once all of the transmitters are registered, it is recommended that you test the chosen mounting locations before
permanently mounting the Control System and wireless devices. You can test the transmitter signal strength using the
Test features.
To test transmitter signal strength:
1.
Press '
√ʹ.
2.
Enter your Installer code.
3.
Enter [7042] (Service, Transmitters, TX Test) to initiate TX Test mode.
4.
Activate the transmitter you wish to test; the transmitter’s details appear on the Control System’s LCD.
Additionally, between one and four tones are sounded to indicate the transmitter’s signal strength. If four
tones are sounded, the transmitter is in the best possible location – see Transmitters for further information.
5.
After you have tested each transmitter, press Χ to exit TX Test mode.
When using the GPRS Module, test the GSM signal strength.
To test the GSM signal strength:
1.
Press '
√ʹ.
2.
Enter your Installer code.
3.
Enter [706] (Service, GSM Signal); the signal strength of the cellular network is displayed – see p. 27,
4.7.10 GSM
Signal Strength for further information.
4.
Check the RSSI (Received Signal Strength Indication) level of the installation environment using the system’s
RSSI meter.
To view the Environmental RSSI level reading:
•
Enter [7044] (Service, Transmitters, Env. RSSI); the current RSSI level is displayed – see p.26,
Environmental RSSI, for further information.
2.2.6.
Step 5 – Programming Internet Options
Internet settings are mostly pre-programmed in the Control System’s default settings. The only settings you need to
program are the Control System’s ID & Password (provided by the ELAS administrator). The following procedures
explain how to program the Control System’s ID (CPID) and Password. For further information regarding other
Internet options and settings, see p. 67,
11 Internet Options.
To program the CPID:
1.
Press '
√ʹ.
2.
Enter your Installer code.
3.
Enter [9573] (Programming, Communications, Internet, CPID).
4.
Enter an ID using the alphanumeric keypad. The ID length must be six up to sixteen characters. The ID must
begin with a letter.
5.
Press '
√ʹ.
To program the Control System’s password:
1.
Press '
√ʹ.
2.
Enter your Installer code.
3.
Enter [9574] (Programming, Communications, Internet, CP Password).
4.
Enter a password using the alphanumeric keypad.
The password length must be six up to sixteen characters. The password must begin with a letter.
5.
Press '
√ʹ.
Summary of Contents for iconnect
