Appendix B: Transmitter Installation
iConnect
Installation Manual
99
Registration Procedure
The keyfob must identify itself to the iConnect Control System as follows:
1.
Set the system to registration mode.
•
Go to the main menu and select [9]>[1]>[2] (Programming > Devices > Keyfobs)
•
Select a Keyfob (1-19) and press '
√ʹ.
2.
Press one of the buttons on the Keyfob, making sure that the Keyfob’s green LED lights up when the button is
pressed.
A flashing red LED indicates a communication problem between the Keyfob and the system.
3.
As soon as 'Save?' appears press '
√ʹ.
During registration, maintain a minimum 1 meter distance between the keyfob and panel.
Deleting a Keyfob
To delete a Keyfob from the system:
1.
Set the system to Delete mode.
•
Go to the main menu and select [9]>[1]>[2] (Programming > Devices > Keyfobs).
•
Select a Keyfob (1-19) and press '
√ʹ
2.
Press >6 > '
√ʹ
.
3.
Press
+
for two seconds until the red led stops flashing
4.
Press
+
for two seconds until the red led stops flashing.
Battery Replacement
If the LED blinks during transmissions, this indicates that the battery is low and need replacing.
Batteries must be replaced within seven days of receiving a low battery indication. The
estimated battery life is 2 years (avg. 4 activations per day).
To replace the battery:
1.
Insert a small screwdriver into the pry-off slot. Carefully twist the screwdriver to separate the front and back of the
casing.
2.
Observing correct polarity, replace the battery.
3.
Close the casing making sure that the front and back click shut.
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries
according to the instructions.
EL-4714 complies with EN-50131 Grade 2 Class II Power Supply Type C.
Keyfobs (EL-4711M/P)
The EL-4711M/P is a keyfob transmitters designed for use with the iConnect Control System. The EL-4711M/P is a one-
button transmitter that generates a Medical/Panic alarm when pressed. The transmitter is water resistant and can be worn
around the neck. Its large button makes it ideal for elderly or sight-impaired users.
Figure B- 34: EL-4711M/P
Figure B- 35: Inserting the Cord (EL-4711M/P)
Summary of Contents for iconnect
