13 System Initialization
iConnect
Installation Manual
73
13.
System Initialization
The Initialization menu offers a number of options that enable you to reset the system. This menu is particularly useful
when re-installing a Control System at a new site. The Initialization function clears the entire system. This restores
programming defaults, clears the log, user codes and the transmitter register. Options are also available that enable you
to clear a specific section of the system’s memory separately.
13.1.
Initialization
The Initialization function clears the entire system and resets factory defaults. If your system does not include multi-
default and multi-language support, skip steps 2 and 3 of the following procedure.
To initialize the Control System:
1.
From the Programming menu, select Initialize, Init All [971]; the system prompts you for confirmation.
2.
For firmware versions that include multi-default and multi-language support, select the set of programming
defaults that you want to load.
3.
For firmware versions that include multi-default and multi-language support, select the required interface
language. Factory programming defaults are restored, the event log is cleared, ser codes and wireless
transmitters are deleted.
During system initialization, recorded vocal messages (Message Center and Home ID) are
not deleted.
13.2.
Default Program Restore
Loading the system’s default program enables you to restore the factory-set programming defaults.
To load the default program:
•
From the Programming menu, select Initialize, Load Defaults [972]; the system prompts you for
confirmation.
13.3.
Clear User Codes
Clear User Codes deletes all programmed user codes and restores the default Master and Installer codes.
To clear user codes:
•
From the Programming menu, select Initialize, Clear Users [973]; the system prompts you for confirmation.
13.4.
Clear Wireless Transmitters
The Clear Wireless Transmitters function enables you to delete all registered transmitters at once.
To clear the transmitter register:
•
From the Programming menu, select Initialize, Clear Wireless [974]; the system prompts you for
confirmation.
13.5.
Find Modules
The Find Modules function runs a diagnostic test that identifies the modules that are connected to the system bus. With
this information, the system knows which add-on modules should be present, enabling supervision for those modules.
To run the Find Modules test:
1.
From the Programming menu, select Initialize, find Modules [975]; the system prompts you for confirmation.
2.
Press '
√ʹ to confirm; the system begins to search for the connected modules. At the end of the search, the modules
that are present are displayed and the system asks if you want to save the displayed list.
If a connected module is not included in the list, check the wiring connections and run this
test again.
Summary of Contents for iconnect
