Electro-Metrics EM-2115, Instruction Manual

Page: 13 / 278

ELECTRO-METRICS EM-2115 0.1 INSTALLATION
(EM2115-0.1-i)
SECTION 0.1
EM-2110
INSTALLATION
0.1 Installation
The EM-2110 is designed for either benchtop operation or installation in a con-
ventional 19-inch equipment rack.
0.1.1 Benchtop Operation
When operating the EM-2110 in a free-standing mode (i.e., benchtop operation)
allow sufficient clearance at the top, rear, and sides of the unit to permit effective convec-
tion cooling to occur.
Do Not stack any equipment on top of the EM-2110, as this will
block the cooling holes in the top cover of the receiver. The operating environment of the
EM-2110 should be keep as cool as possible, not exceeding 30°C-35°C (86°F-95°F).
0.1.2 Rack Mounting
To rack mount the EM-2110, using slide mounts, use the following procedure.
a. Pry off the black decorative covers at each end of the handles.
b. Remove the one (1) 6-32 and one (1) 4-40 pan-head screws which secure
the handles to the unit.
c. Remove the handle mounting bases and spacers (each side).
d. Remove the handles and decorative shims (two each side, total: four).
e. Remove all flat-head screws from the side center bars except for the two
(2) screws near the front of the unit.
NOTE: Until the slide mounts are installed, the unit should be
handled with care as the case will be weakened with the
removal of the above hardware.
f. Secure the slide mounting assembly in the handle mounting groove using
the following flat-head screws from front to rear:
1) One (1) 6-32 X 3/8.
2) One (1) 6-32 X 9/16.
3) One (1) 6-32 X 1/2.