70
Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
Figure 53. Inserting the Rear Hold-Down Bracket
NOTE
Treat the electronics module with care to avoid damaging the fans, connectors, or
internal circuitry.
16. Replace the electronics module by sliding it carefully into the cabinet. Push the electronics module firmly
to seat the connectors.
17. Reinstall the electronics module locking screw.
18. On the UPS rear panel, plug in the supplied communication terminal block connectors.
19.
Optional but recommended.
Press the two supplied wire saddles into the holes on the rear panel, as
shown in During wiring installation, secure any wires to the connectors within the saddles.
Figure 54. Installing the Communication Terminal Block Connectors
3-Pin Connector
2-Pin Connector
2-Pin Connector
2-Pin with Jumper
2-Pin Connector
2-Pin with Jumper
Wire Saddle
Wire Saddle
20. Continue to the Installing the UPS Internal Batteries section.
Summary of Contents for BladeUPS none
