38
Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
•
Locate the top panel trim assemblies and the 12 screws that you removed previously.
•
Replace the outside pairs of trim screws on the first trim assembly, and then replace the interior trim
screws.
•
Repeat to install the second trim assembly.
13. Replace the two upper side panels:
•
Locate the two upper side panels and the key.
•
Slide the bottom lip of the first panel into the track above the bottom panel.
•
Push the panel forward until it is flush with the rack frame.
•
Snap the panel into the latches.
•
Lock the upper side panels with the key.
•
Repeat to install the second panel.
14.
Five and six UPS preassembled systems only.
Continue to section
“Installing the UPS Internal
Batteries ” .
15. If installing optional EBM(s), continue to section
“EBM Installation” . Otherwise, go to section
“Parallel System Initial Startup Section” .
33..1111
B
Boottttoom
m EEnnttrryy IInnssttaallllaattiioonn
Bottom Entry Installation
shows input and output wiring in a bottom entry system.
Figure 19. Bottom Entry Wiring Installation
Summary of Contents for BladeUPS none
