Eaton BladeUPS none, User Manual

Page: 78 / 160

64 Eaton BladeUPS 5 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 14
• Tighten the top panel screws.
8. Replace the trim:
• Locate the top panel trim assemblies and the 12 screws that you removed previously.
• Replace the outside pairs of trim screws on the first trim assembly, and then replace the interior trim
screws.
• Repeat to install the second trim assembly.
9. Replace the two upper side panels:
• Locate the two upper side panels and the key.
• Slide the bottom lip of the first panel into the track above the bottom panel.
• Push the panel forward until it is flush with the rack frame.
• Snap the panel into the latches.
• Lock the upper side panels with the key.
• Repeat to install the second panel.
10. If installing optional EBM(s), see the EBM Installation section.
Otherwise, continue to the UPS Setup section.
NOTE 1 If you are installing the EBM with a new UPS at the same time, use the UPS user’s
guide to install both the UPS and the EBM.
NOTE 2 Mounting rails are required for each individual cabinet.
44..88 U UP PS S S Seettuupp
The UPS comes with all hardware required for installation in a standard EIA or JIS seismic rack-mount
configuration with square and round mounting holes. The rail assemblies adjust to mount in 48-cm (19-inch)
racks with front to rear rail distances from 61 to 76 cm (24 to 30 inches) deep.
44..99 C Chheecckkiinngg tthhee U UP PS S A Acccceessssoorriieess
Verify that the following items are included with the UPS:
• UPS front cover
• Communication terminal block connectors:
– (3) two-pin connectors
– (2) two-pin connectors with jumpers
– (1) three-pin connector
• (2) wire saddles
• Communication cable (DB-9/DB-9)
• Documentation and software tools
– Software Suite CD
– BladeUPS: Documents, Firmware, and Installation Video CD
– This user’s guide
UPS Setup