Dräger Julian, Operating Instructions Manual

Page: 36 / 148

Electrical Connections
Auxiliary electrical systems
1 Connect to one of the auxiliary power outlets on the
back of the workstation.
Equipotential bonding
e.g. for intracardial or intracranial operations.
2 Connect one end of the grounding cable to one of the
grounding pins on the back of the workstation.
●
Connect the other end of the grounding cable to the
specified equipotential bonding point, e.g. on the
operating table or ceiling lamp.
Connecting to line power
The line voltage must be the same as specified on the
rating plate on the back of the workstation.
Voltage range: 85 to 265 V
●
Plug power plug into wall outlet.
WARNING !
To maintain grounding integrity, connect only
to a "hospital grade" receptacle. Always
disconnect supply before servicing.
WARNING !
Restrictions for use of auxiliary power outlets
●
Do not connect HF surgical devices to the
auxiliary outlets!
●
Connecting equipment to the auxiliary outlets
may cause the patient leakage current to rise
above the permitted values in the event of
failure of a protective ground conductor.
In such cases, the risk of electric shock cannot
be excluded.
●
Additional power strips must not be connected
to the auxiliary outlets.
WARNING !
Devices connected to auxiliary power outlets
will not be powered by the uninterruptible
power supply in the event of a power failure.
Preparation
Connecting Supplies
Electrical Connections
Operating Instructions Julian SW 3.n
36
1
2