AT Commands
F-16 AT Commands
*E
n Enable Remote Access
*E0
Disables remote access.
*E1
Enables remote access.
Determines how the modem responds to a request for remote access. Remote access is
available only during a normal connection or during an MNP reliable connection
without data compression.
NOTE
The modem does not support remote access during LAPM reliable connections.
-E
n Modem Port Data Length
-E0
Enables 10-bit data during normal mode connections.
-E1
Enables 11-bit data during normal mode connections.
Determines the number of data bits used on the modem port during normal mode
connections (when \N0 is set) when the serial port is configured for asynchronous
transmission of 11-bit characters. Both modems must be set to the same number of data
bits.
NOTE
The modems will not be able to pass data when a reliable connection (\N3 or \N5
is set) falls back to a normal connection with 11-bit data characters enabled on
both modems.
.
:E
n Compromise Equalizer
:E0
Disables the compromise equalizer only when the modem is in V.32bis or V.32 mode;
may be useful for direct line connections or PBX-to-PBX connections.
:E1
Enables the compromise equalizer; may be useful for outside-line-to-outside-line or
PBX-to-outside-line connections.
Controls equalization operation when the modem connects in V.32bis or V.32.
