DH Instruments COMPASS FOR MOLBOX, User Manual

Page: 79 / 226

COMPASS

for molbox™ User’s Manual
Page 65
© 1998-2003 DH Instruments, Inc .
Figure 37. <DUT Selection> Tool
8.5 DUT DEFINITION EDITOR
All DUT Definitions are created or edited using the DUT Definition Editor. The Editor also acts as a viewer
in other
COMPASS functions. When editing a DUT, verify that each Editor tab contains the proper
information. This will help to avoid conflicts when using the DUT Definition in a COMPASS run mode.
Refer to Sections 8.5.1 through 8.5.9 for detailed information on the features and entry fields of the DUT
Definition Editor.
The DUT Definition Editor is made up of multiple sections:
•
<Toolbar> (see Section 8.5.1): Includes tools to identify and select DUT Definitions and icons to
create, save, copy and delete Definitions.
•
[Header] Tab (see Section 8.5.2): Contains general DUT identifying information and the Profile or
Individual type choice.
•
[Correction] Tab (see Section 8.5.3): Specifies whether a gas density correction should be made for
the DUT and the DUT’s standard operating gas pressure and temperature conditions.
•
[Range] Tab (see Section 8.5.4): Defines the DUT’s flow and measurement output unit and range.
Specifies if the DUT is a flow controller.
•
[Tolerance] Tab (see Section 8.5.5): Specifies the DUT’s measurement tolerance type and
quantifies the tolerance.
•
[Test] Tab (see Section 8.5.6): Identifies the default Test Definition to be used when the DUT is
selected in [Run Test] mode.
•
[Conditions] Tab (see Section 8.5.7): Records conditions under which the DUT is tested (orientation,
downstream pressure).
•
[Read] Tab (see Section 8.5.8): Defines the DUT’s output type and commands to be used.
Sets resolution to use when running tests.
•
[Set] Tab (see Section 8.5.9): If the DUT is a flow controller, defines the set point type and range and
commands to be used in the case of RS-232 or IEEE-488 DUTs.