DH Instruments COMPASS FOR MOLBOX, User Manual

Page: 31 / 226

COMPASS

for molbox™ User’s Manual
Page 17
© 1998-2003 DH Instruments, Inc .
Next, the <Setup DUT> screen displays for the final setup of the DUT serial
number, identification (for DUT Profiles only) and RS-232 settings. Enter the
DUT serial number and identification if desired then click the
<Read Interface>
RS-232 settings display to display the RS-232 setup window. Make the necessary
RS-232 selections and press
<OK> (see Section 7.2.1.5). The selected settings
are automatically copied to the <Set Interface> . Press <OK> on the <Setup DUT(s)>
screen to start the test. COMPASS will step through the test point sequence
gathering data from the reference and the DUT (see Section 7.2.2).
Figure 5. Example 1, DUT Interface Setup
The COM2 port of the molbox can be used instead of a communications port
on the PC by selecting <Ref Com2> found at the end of the <COM Port> list.
This selection is valid for any RS-232 device except the molbox itself.
Figure 6. Example 1, RS-232 Setup with Ref Com2