DH Instruments COMPASS FOR MOLBOX, User Manual

Page: 109 / 226

COMPASS

for molbox™ User’s Manual
Page 95
© 1998-2003 DH Instruments, Inc .
Figure 55. Test Definition Editor, [Data] Tab
Table 32. Test Definition Editor, [Data] Tab Fields
FEATURE DESCRIPTION
Read DUT
Output
(check box)
When checked, the DUT output is read during the test and logged in the Data
File. If not checked, no prompts for DUT output will occur regardless of the DUT
<Output Type> (see Section 8.5.4). Note that no DUT flow will be determined,
therefore, no flow errors will be available on the <DUT/Ref Comparison>
window. This impacts reporting and plotting functions as well. Uncheck this
option only when DUT flow information is not desired.
Read DUT Set
Point
(check box)
When checked, the DUT <Measured Set Point> is read and logged during the test.
This applies only to DUTs that are set up as a controller using
<Voltage/Current><Set Point Type> (see Sections 8.5.4, 8.5.9). All set errors
will be based on this measured value. If the value is not checked, set errors are
based on the nominal test set point.
Read DUT
Pressure
(check box)
When checked, DUT pressure is read and logged during a test. If a remote
pressure device is set up in the System Configuration (see Section 10.2), the
pressure is logged automatically. Otherwise, manual entry of pressure is
required. If the DUT uses a density correction (see Section 8.5.3) or an actual
flow unit, pressure is logged in the Data File regardless of this selection.
Read DUT
Temperature
(check box)
When checked, DUT temperature is read and logged during a test. If a remote
temperature device is set up in the System Configuration (see Section 10.2),
the temperature is logged automatically. Otherwise, manual entry of
temperature is required. If the DUT uses a density correction (see Section 8.5.3)
or an actual flow unit, temperature is logged in the Data File regardless of this
selection.