WARNING - Explosion Hazard - Do not disconnect equipment unless power has been removed or the
area is known to be non-hazardous
WARNING - Explosion Hazard - Do not utilize any of the connectors/hubs unless area is known to be
non-hazardous
9.2.1
PC Card
1.
Lower the hinged door on the left side of the system that protects the PC card slot. See “
190H
Left Side View”.
2.
Hold the card with its orientation symbol pointing into the slot and the top side of the card facing up. The latch
may need to be in the "in" position before you insert the card.
3.
Slide the card into the slot until the card is completely seated in its connector.
If you encounter too much resistance, do not force the card. Check the card orientation and try again.
The computer recognizes most PC Cards and automatically loads the appropriate device driver. If the configuration
program tells you to load the manufacturer's drivers, use the floppy disk or CD that came with the PC Card.
9.2.2
ExpressCard
1.
Place the ExpressCard in the adapter (the adapter is included with the ExpressCard).
2.
Install the ExpressCard with adapter the same way as a PC Card (see "
191H
PC Cards").
9.3
Removing a Card or Blank
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
192H
Safety Information section of this manual.
NOTICE: Click the
icon in the taskbar to select a card and stop it from functioning before you remove it from
the computer. If you do not stop the card in the configuration utility, you could lose data. Do not attempt to eject a
card by pulling its cable, if one is attached.
Press the latch and remove the card or blank. For some latches, you must press the latch twice: once to pop the latch
out, and then a second time to pop the card out.
10
Securing Your Computer