Davin J012, Service Manual

Page: 175 / 365

Code Possible Cause
0056 Modem disconnected after CFR sent in V.34.
0058 No image signal detected within 6 sec. after modem entered primary phase in V.34.
0059 Relay box deleted while relay job was being received.
005A Modem did not detect a correct ECM frame with 3 min. in phase C.
005B No phase 5 signal detected after primary channel within 6 sec.
005C Busy tone detected on control channel after phase C.
005D Modem did not detect a correct ECM frame within 12 sec. in phase C.
005E No control channel signal detected within 6 sec. after RCP frame was received.
005F No silence detected after JM signal was sent during TX polling.
0060 No bulletin files to be polled in V.34.
0061 No V.21 or V.8 signal detected with 35 sec.
0062 Modem disconnected in phase D after local machine sent flag sequence on control channel.
0063 No flag sequence on control channel within 6 sec. in phase D.
0064 No control channel signal received in phase D within 60 sec. even with power on the line.
0065 Cannot detect any control channel signal within 60 seconds after detect silence in phase D.
0066 No T.30 signal or carrier received after CFR was sent in V.34.
0069 Paper size mismatch after DCS signal received.
0070 Operator press [Stop] key during receiving.
0071 Memory became full during receiving.
Communication (TX)
Code Possible Cause
0080 No G3 signal detected within 35 sec. in Phase B as specified by ITU-T.
0081 Received DTC signal in TX phase.
4. Troubleshooting
174
4