DAHAO BECS-185, Owner'S Manual

Page: 201 / 236

Appendix 1 Parameter List
Owner’s Manual of BECS- 185 Computerized Control System 189
No. Name of Parameter Default Value Range of Value Remarks
280,290
B03 Over frame by Step No No, Yes
C15 High Frame-Shift
Speed
16 1~30
C16 Low Frame-Shift
Speed
15 1~30
D13 Speed When Over
frame
16 0,1,2,…,30
C72 Emb. Mode Flat Flat, Cloth, Cap
Main Shaft Parameters
C07 Max. Speed 700-850 250, 300, 350,…,1000
C09 Minimum Speed 400 250,300,350,…,600
C08 Shift Stitch Length
（
mm
）
3.0~6.0
(All-servo
high speed
machine)
1.0~10.0(common
type machine), 3.0~
6.0 (high-speed
machine using Dahao
servo-motor driver)
When the stitch length is
longer than the set value, the
machine will lower the speed.
C10 Jump Stitch Speed 500 400~750(common
type machine), 400~
1100 (high-speed
machine using Dahao
servo-motor driver)
Set the rotation speed for jump
stitch.
C12 Startup Stitches 1 stitch 1 stitch~9 stitch Set the startup stitch number
before acceleration.
D02 Startup Acce. 12 1,2,3,…,30 Increase the value to bring a
quicker speedup after pressing
the start key.
C25 Set Break Para. 0 0~30 Range: 0~30. When the main
shaft motor is an
electromagnetic motor, the
value is usually set at 9. When
it is a servomotor, the
parameter is usually set at 5-7.
D14 Stop Ok bef. Pull
Bar
Yes No, Yes
C26 Para. Of Needle
Down
0 0~30
Thread-trimming Parameters
C01 Jump & Trim 3 Jump No Trim, 1 Jump~7