DAHAO BECS-185, Owner'S Manual

Page: 208 / 236

Appendix 3 Error List
196 Owner’s Manual of BECS- 185 Computerized Control System
Appendix 3 Error List
Note: for the errors listed below, you may click “Clear” to check related parts. Follow the
instructions at below. If the machine has no password-protected function, please omit the items
relating to password at below:
Error Number Error Solutions
Upper Machine Error
01 Operation Failure
02 Operation Stop
03 Communication Error to Down
Machine
Repower the machine
06
Not set ZERO point
Perform the “Set Frame
Origin/ Power-off Protection”
07 Fail to set ZERO point Reset it.
08
No design start point
Perform “Save Design Start
Point”
09
No software range
Perform “Set Frame Soft
Protection”
10 Password is wrong! Input the right passwords
11 New passwords not same Re-input
12 Emb. design not existed! Design has been deleted
13 Dest. design existed! Re-perform the operation or
perform the operation after
repower or perform the
operation after the “Clear All
Memory Design”
14 Design not existed!
15 Open design error!
16 Error type combined design
17 Open FLASH media error
18 Design has created!
19 No enough design mem. Delete some designs
20 Directory is invalid. Re-perform the operation or
perform the operation after
repower or perform the
operation after the “Clear All
Memory Design”
21 FLASH media write-protect
22 Design file not existed
23 Design name is invalid
24 Design file corrupt Re-perform the operation or
perform the operation after
repower or perform the
operation after the “Clear All
Memory Design”
25 Error read/write design
26 Not open design file
27 FLASH media I/O Error
28 Device not existed! Re-plug or repower machine