DAHAO BECS-185, Owner'S Manual, Page: 170 / 236

Chapter 11 About JF Sequin Embroidery
158 Owner’s Manual of BECS- 185 Computerized Control System
d) Use or until you see “END” in “Sequin mode”, then press
to confirm and save the settings. Clicking is to keep the sequin mode
before the edition.
For example: a machine with needle No. 9 as its end needle (tri-sequin at 3, 5, 7mm); first
needle is single sequin (9mm). The requirement is 7mm at first, then 3 & 5mm overlap, then 5
and 7mm alternate embroidery, then sew 9 pieces of 3mm, 8 pieces of 5mm, 4 pieces of 7mm,
6 pieces of 3 & 7 overlap sequins, at last, use first needle to embroider 9mm sequins
Procedure of Setting:
(1)
①
Click 9 to activate the interface for setting sequin-feeding mode;
②
Click or until “C” appears, then click
；
③
Click “1”, then click ;
④
Click or until “End” appears, then click to finish the first
setting.
(2)
①
Click 9 to activate the interface for setting sequin-feeding mode;
②
Click or until “AB” appears, then click ;
③
Click “1”, then click ;
④
Click or until “End” appears, then click to finish the setting.
(3)
①
Click 9 to activate the interface for setting sequin-feeding mode;
②
Click or until “B” appears, then click ;
③
Click “1”, then click ;