DAHAO BECS-185, Owner'S Manual

Page: 166 / 236

Chapter 11 About JF Sequin Embroidery
154 Owner’s Manual of BECS- 185 Computerized Control System
2
、
L/R Sequin Feeding Angle Adjustment
This parameter is to adjust the sequin-feeding angle.
3
、
Auto Start for Sequin
When the setting is “Yes”, system will start embroidering sequin automatically.
When the setting is “No”, machine needs manually start at sequin embroidery.
4
、
Time of Sequin Action
This is to set the time from sequin device going down to starting embroidery (0-15, the
default value is 2). If the sequin-feeding device is controlled by valve, use the default value; if
that device is controlled by motor, please set it at 4~5.
5
、
Sequin off after T.B.
When the setting is “Yes”, sequin presser foot will be up automatically in case of
thread-breakage.
When the setting is “No”, the user needs to lift the presser foot manually at
thread-breakage.
6
、
Sequin Ind. Up/Down
When the setting is “Yes”, the sequin devices will move independently. When the
setting is “No”, they will move collectively
7
、
Lift Valve at Jump without Trim (Y/N)
8
、
Base of Shift Travel at L/R Motor
9
、
Multiple of Shift Travel at L/R Motor
10
、
Has Origin at Shifting L/R Motor
The parameter No.8, No.9 and No.10 are for the special sequin device that uses the motor
(Single Needle Double Sequin) to shift the travel between large sequins and small sequins.
There are two kinds of device: one has the shift origin; the other has no shift origin.
11
、
L/R Trimmer Action Angle Adj.
This parameter is used at the special sequin device that uses motor to cut the sequin for
adjusting the start time of the sequin-cutting motor. The default value of it is 15. The smaller
value means the earlier action of motor, the range of this value is 0~31.