xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
411
Example
To enable unidirectional link detection on port 1:
DGS-3620-28SC:admin# config duld ports 1 state enable
Commands: config duld ports 1 state enable
Success
DGS-3620-28SC:admin#
30-2
show duld ports
Description
This command is used to show unidirectional link detection information.
Format
show duld ports {<portlist>}
Parameters
ports
- (Optional) Specify a range of ports to be display.
<portlist>
- Enter the list of ports to be displayed here.
If no ports are specified, all the ports will be displayed.
Restrictions
None.
Example
To show ports 1-4 unidirectional link detection information:
DGS-3620-28SC:admin#config duld ports 1,2,4 state enable
Commands: config duld ports 1,2,4 state enable
Success
DGS-3620-28SC:admin#show duld ports 1-4
Commands: show duld ports 1-4
port Admin State Oper Status Mode Link Status Discovery
Time(Sec)
---- ----------- ----------- ---------- -------------- ------------
-------
1 Enabled Enabled Shutdown Bidirectional 5
2 Enabled Enabled Normal RX Fault 5
3 Enabled Enabled Normal TX Fault 5
4 Disabled Disabled Normal Unknown 5
5 Enabled Enabled Normal Link Down 5
DGS-3620-28SC:admin#
