xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
899
Parameters
<portlist>
- A range of ports to display. If not specifying any ports, the DSCP trust status for all
ports on the switch will be displayed.
Restrictions
Only Administrator, Operator level users can issue this command.
Example
To enable DSCP trust on ports 1:1-1:8:
DGS-3620-28SC:admin#show dscp_trust 1:1-1:8
Command: show dscp_trust 1:1-1:8
Port
DSCP-Trust
----- -----------
1:1
Disabled
1:2
Disabled
1:3
Disabled
1:4
Disabled
1:5
Enabled
1:6
Enabled
1:7
Enabled
1:8
Enabled
DGS-3620-28SC:admin #
81-18
config dscp map
Description
This command is used to configure the mapping of DSCP to a priority.
Format
config dscp map [<portlist> | all] [ dscp_priority <dscp_list> to <priority 0-7> |
dscp_dscp <dscp_list> to <dscp 0-63>]
Parameters
<portlist>
- A range of ports to display. If not specifying any ports, the DSCP trust status for all
ports on the switch will be displayed.
all
-
Specifies that the command applies to all ports on the switch.
dscp_priority
- Specifies a list of DSCP values to be mapped to a specific priority.
<dscp_list>
- Enter the dscp list number here.
<priority 0-7>
- Specifies the result priority of a mapping.
dscp_dscp
- Specifies a list of DSCP values to be mapped to a specific DSCP.
<dscp_list>
- Enter the dscp list number here.
<dscp 0-63>
- Specifies the result DSCP of mapping.
