Crystal Vision
Installation
TANDEM-200 User Manual R1.7
122
13/02/2008
AIP2-HP
This analogue audio input module provides identical connections to the standard AIP2,
but with better performance. The higher power requirement means that TANDEMs fitted
with one or two of these modules should be associated with a vacant slot. For this reason
it is best used with the RM06 or RM36 (one card in two slots) or with the RM05 (two
cards in slots 1 & 3 out of four), which provide the maximum available connections.
Link jumpers are provided to allow 0dBFS to be set to +18dBu (rearwards, towards J1) or
+24dBu (forwards, towards J2/3). The variable adjustments on the card are set at the
factory and should not require re-adjustment. Set channel 1 with JL4/RV4, channel 2 with
JL2/RV2, channel 3 with JL1/RV1 and channel 4 with JL3/RV3.
Take care to note the
adjustment and channel numbering on this sub-board.
DOP2-110
This digital audio output module provides 2 110 Ohm AES stereo pairs or four mono
outputs that may be used as destinations when routing de-embedded signals.
In addition, jumper links are provided to configure an optional external reference when
using the RM04, RM05 RM06 and RM36 rear modules, in place of a 2
nd
buffered output.
The reference may be selected between AES reference or word clock with JL4. Use JL3
and JL4 together to select between AES2 (2
nd
buffered output – upper two pins) or REF
I/P (external reference – lower 2 pins). Link jumper JL1 is provided to select the external
reference input, which is always fed via a ‘D’ connector, between 110 Ohm (upper 2
pins), HiZ (balanced – centre pin only) or 75 Ohm (unbalanced – lower 2 pins).
J1
^AES
¬Word Clk
^AES2
¬REF I /P
^110R
¬75R
> OPEN=HI Z
J2
J3
CRYSTAL VISION LTD
110R DOP
JL1
JL4
JL3
JL2
J1
JL 1 ~ 4
< 24 dBu
> 18 dBu
J2
J3
CRYSTAL VISION LTD
Aip HP
JL4
RV4
RV2
RV1
RV3
JL2
JL1
JL3
