Crystal Vision
Statesman operation in mode 2
TANDEM-200 User Manual R1.7
43
13/02/2008
Preset Controls
The Preset Controls menu provides access to setup presets, monitoring assignments and
SDI crystal PLL embed reference selection.
Preset Controls menu
Using Presets
Up to sixteen setups may be stored and recalled from Statesman, the card edge control or
by external GPIs. Presets store board setup data including operating mode and option card
status. It is not possible to recall a preset if the operating mode or option card
configuration is different to those established when the preset was created. The presets are
currently numbered 0-15.
To store a preset proceed as follows:
•
Ensure ‘GPI controls preset recall’ is unchecked
•
Select appropriate preset with the Preset Number drop-down menu
•
Click on ‘Check\Preset’ to find an empty preset
•
Click on ‘Store’ to save setup data into the selected preset
To recall a preset proceed as follows
•
Ensure ‘GPI controls preset recall’ is unchecked
•
Select appropriate preset with the Preset Number drop-down menu
•
Click on ‘Recall’ to recall setup data from the selected preset
‘GPI controls preset recall’ should not be checked whilst presets are being created or
recalled by this menu to prevent inadvertent GPI operation. Enable ‘GPI controls preset
recall’ when finished if required.
Audio Monitoring
A powerful 16-source stereo monitoring bus provides audio monitoring at the card-edge
headphone socket and rear connector.
The 16-source stereo selectable analogue monitoring output is fed to a miniature stereo
jack socket at the card edge. Select any valid stereo signal to be monitored with the
monitoring drop-down list.
