Crystal Vision
Statesman operation in mode 4
TANDEM-200 User Manual R1.7
61
13/02/2008
Using Output Routers
Select an Output router to choose external audio destinations.
Side 1 Output Router for mode 4
Sources from the ‘A’ de-embedder on side 1 can be routed to channels 1&2 of any
external ‘J’ output audio option card.
Side 2 Output Router for mode 4
Sources from the ‘B’ de-embedder can be routed to channels 3&4 of any ‘J’ external
output option card.
Route source to destinations by clicking on the crosspoint squares in the matrix. Any
selections made will turn dark red. Invalid selections will be rejected. Click on the Salvo
button when finished. Valid selections will turn bright red and new source-destination
assignments will be loaded into the output routing table.
The warning text ‘delay unavailable (used on D)’ may be shown to indicate that delay
will not be available to an output router (even if delay boxes can be checked) if the
associated embedder (C for side 1 and D for side 2) has been turned on. This occurs
because there is only one delay function available on each TANDEM-200 side.
To assign delay to an output router ensure that ‘none’ has been selected in the Audio
Groups Out section for the appropriate TANDEM-200 side. Selecting ‘none’ for no
embedded audio group turns off the embed function and releases the delay function to the
output router.
Note:
SDI routing between sides is not supported in mode 4.
