Crystal Vision
Statesman operation in mode 2
TANDEM-200 User Manual R1.7
41
13/02/2008
Using the Output router
Select the Output router to chose external audio destinations.
Output Router for mode 2
Sources from the ‘A’ de-embedder can be routed to any external ‘I’ output audio option
card on ‘side’ 1. Sources from the ‘B’ de-embedder can be routed to any external ‘J’
output option card on ‘side’ 1.
Route source to destinations by clicking on the crosspoint squares in the matrix. Any
selections made will turn dark red. Invalid selections will be rejected. Click on the Salvo
button when finished. Valid selections will turn bright red and new source-destination
assignments will be loaded into the output routing table.
The warning text ‘delay unavailable (used on D)’ may shown to indicate that delay will
not be available to an output router (even if delay boxes can be checked) if the associated
embedder has been turned on. This occurs because there is only one delay function
available on each TANDEM-200 ‘side’.
Note:
To enable output delay for ‘I’ destinations, turn off the ‘C’ embedder by setting the
audio group out to ‘none’.
To enable output delay for ‘J’ destinations, turn off the ‘D’ embedder by setting the
audio group out to ‘none’.
Editing router input and output names
Each of the input and output names may be edited for both embed and output routers.
Changing router input name
Changing router output name
To edit a source or destination name click on the Input or Output text, and a Rename
menu will appear. Enter the desired names in the box provided and click OK. The new
name will be stored in the host PC, and appear each time Statesman is used.
