Crystal Vision
Installation
TANDEM-200 User Manual R1.7
120
13/02/2008
To fit a sub-module proceed as follows:
•
ensure that all static electricity precautions have been taken
•
fit two module retaining screws (3x10mm) from below the main PCB, and add a
nylon spacer (3x3mm) on top of the TANDEM PCB to each screw for each sub-
module location – hold screws firmly in place
•
offer up the chosen sub-module to its intended position on the TANDEM main
card
•
check that the orientation is correct and that retaining holes and header sockets
line up with the corresponding holes and header plugs on the main card
•
push the sub-module in place firmly taking care not to bend any pins
•
fit the retaining fibre washers, internal serrated washers and nuts to the two
retaining screws
Removal is the reverse of the above procedure.
Notes:
All items are supplied with the TANDEM module.
All sub-modules must be fitted with the component side uppermost and flat (track side)
down, facing the TANDEM PCB. Fitting sub-modules with the component face
downwards may result in fatal damage.
To check which modules are fitted when a TANDEM is already in place in its frame, use
the option status check (status menu 5) explained in section 9.2.
