Crystal Vision
Installation
TANDEM-200 User Manual R1.7
121
13/02/2008
10.6 Sub-module
link
settings
AOP2
J1
JL 1 ~ 4
^24 dBu
¬18 dBu
J2
J3
CRYSTAL VISION LTD
Aop
JL2
JL1
RV1
RV2
RV3
RV4
JL4
JL3
The analogue audio output module provides 2 stereo pairs or four mono outputs that may
be used as destinations when routing de-embedded signals. Link jumpers are provided to
allow 0dBFS to be set to +18dBu or +24 dBu. The variable adjustments on the card are
set at the factory and should not require re-adjustment. Set channel 1 with JL1/RV1,
channel 2 with JL2/RV2, channel 3 with JL3/RV3 and channel 4 with JL4/RV4.
Selectable jumper links are provided to change input and reference terminations and pre-
set levels, depending on sub-module features.
AIP2
The AIP2 is identified on the silkscreen as the AIP2-LP to indicate its lower power
consumption. The analogue audio input module provides 2 stereo pairs or four mono
signals that may be used as a source in subsequent embedding. Link jumpers are provided
to allow 0dBFS to be set to +18dBu (rearwards, towards J1) or +24dBu (forwards,
towards J2/3). The variable adjustments on the card are set at the factory and should not
require re-adjustment. Set channel 1 with JL4/RV4, channel 2 with JL2/RV2, channel 3
with JL1/RV1 and channel 4 with JL3/RV3.
Take care to note the adjustment and
channel numbering on this sub-board.
J1
JL 1 ~ 4
< 24 dBu
> 18 dBu
J2
J3
CRYSTAL VISION LTD
Aip LP
JL4
RV4
RV2
RV1
RV3
JL2
JL1
JL3
