Crystal Vision
The active control panel
TANDEM-200 User Manual R1.7
74
13/02/2008
Assign Audio Routing
Description
Audio routing: destinations depend on options fitted
F1 = Sdi 1 – if input option fitted on side 1
F2 = Sdi 2 – if input option fitted on side 2
F4 = Aop/Dop – if output option fitted on side 1, else out1
F4 = Aop/Dop – if output option fitted on side 2, else out 2
‘Destination’ may be Embedder1, Embedder 2, OP Option 1
or OP Option 2
Select appropriate ‘F’ button to route to audio channels 1-4
Select ‘source’ with shaft encoder to route to ‘destination’
and ‘channel’ chosen in previous menu
Source may be Dmx1, Dmx2, Opt1, Opt2
Destination may be Mux1, Mux2, Opt1, Opt2
Shaft encoder also selects Delay (D), Inversion (/) and
Normal (>)
Notes:
Audio assign menu, (1.2.4) may be used as a status display to read current audio routing
assignments using providing F1 (Acc) is not pressed.
Use F2 in menu 1.2.4 to cycle through delay and/or phase inversion choices.
Out 1 and Out 2 are used to refer to Demux outputs available to the analogue monitor
function when there is no output option-card
Delay and phase codes:
The following codes are used for delay and phase inversion
>
D>
/
D/
Normal phase and no delay
Delay
Inverted Phase
Delay + inversion
Tip:
If TANDEM-200 firmware or sub-boards have been changed it is recommended to start
by loading valid default settings for the entire routing table held in TANDEM’s non-
volatile memory. This will prevent erroneous settings from appearing in the routing
assignment menus. From firmware V5.15 this function is performed automatically (card-
edge display shows Save Pre15 > Pre1). Please refer to Using card edge controls section
9.3 if default settings are required. Audio group selection should be checked after
loading default routing.
