![background image](http://html1.mh-extra.com/html/conair/320csc2/320csc2_user-manual_2649055097.webp)
To replace puller belts:
Turn the rotary disconnect to the OFF posi-
tion.
Remove the upper and lower belt guards.
Release belt tension
by loosening the threaded
rods. Keep tension on front and back edges as even as
possible by turning each rod 5-10 revolutions, then
switching to the other side. Continue until the belt is
loose enough to slide off the puller.
1
2
3
Remove the belt from the puller.
Check the
rollers and pulleys for buildup, especially inside grooves.
Clean if necessary.
4
R
EPLACING
B
ELTS
UGE048/1103
CSC Combination Puller/Cutter
M
AINTENANCE
5-17
Reverse the process to install the new belt.
Make sure ribs inside the belt fit properly into grooves,
and keep tension on front and back sides as even as possi-
ble by alternating between the two threaded rods.
Adjust belt tension and belt gap.
See
Testing Belt
Tension, Section 5.
5
6