CSC Combination Puller/Cutter
UGE048/1103
T
ROUBLESHOOTING
6-18
C
HECKING THE
M
OTOR
/
REDUCER
A
SSEMBLY
Open the knife guard.
Remove the cutter head
by loosening the
Trantorque assembly. Refer to the manufacturer's guide
included with this User Guide for information about the
Trantorque assembly.
Locate the four bolts
holding the motor/reducer
assembly to the cutter. Remove them and carefully
remove the assembly from the cutter.
Refer to the Micron installation
and maintenance
information included with this User Guide to check and
adjust the motor/reducer assembly.
1
3
2
4
When the encoder is working properly, the measurement dis-
played will count up to the preset and reset to zero.
Check all connections.
Check the encoder cable for damage.
If neces-
sary, replace.
Check the connector that attaches the cable to
the encoder.
Internal wiring may be shorted out if this
connector is not handled properly.
Check the encoder itself.
There should be no play in
the shaft.
If all else fails,
contact Conair Customer Service.
See
Appendix A.
WARNING: Delicate equipment
The encoder is a delicate piece of equipment.
Any rough handling can damage fragile parts.
5
1
2
3
4
C
HECKING THE
E
NCODER