![background image](http://html1.mh-extra.com/html/conair/320csc2/320csc2_user-manual_2649055062.webp)
4-20
O
PERATION
CSC Combination Puller/Cutter
UGE048/1103
If a negative symbol is shown to the left of the count value on
the main mode screen the encoder signal is reversed, i.e. rotat-
ing in the wrong direction. The Cutter will not function while
the encoder is going negative. The direction function corrects
this by changing what the servo drive interprets as a positive
direction, CW or CCW rotation.
UNIT OF MEASURE SOFTKEY
By pressing the soft key located under the word U/M on the
Encoder Area screen, the Eng. Units can be set.
Exit or Prev
, Pressing Exit or Prev will return the display to
the Encoder Area screen.
in./mm. Softkeys
Pressing the soft key located under in. or mm. Changes all
displayed measurements to the respective unit of measure.
The scaled distance must now be set for the desired unit. See
the Scale Area Dist. Softkey description.
Scale Softkey
By pressing the soft key located under the word Scale on the
Encoder Area Screen, there are two sub-menus, Dist., and
Counts accessible.
Additional information on how to access
this screen can be found in the Maintenance Area of the oper-
ator display overview in Appendix E of this manual.
Exit or Prev
, Pressing Exit or Prev will return the display to
the Encoder Area screen.
SETTING THE SCALE FACTOR
The Encoder mode uses a scale factor to compensate for con-
figurations that differ from the standard (a measuring wheel
with a 1 foot circumference; a 3000 bi-directional quadrature
pulse encoder; and English units of measure). The prescale
value is set at the factory for your equipment and typical unit
of measurement. However, it may occasionally be necessary
to adjust the prescale value.
C
UTTER
C
ONTROL
I
NSTRUCTIONS
U
NIT
OF
M
EASURE
SEL. UNIT OF MEASURE
in.
Exit
mm.
SELECT SCALE AREA
Dist.
Exit
Counts
C
ONTROL
I
NSTRUCTIONS
E
NCODER
D
IRECTION
CONTINUED