CSC Combination Puller/Cutter
UGE048/1103
3-8
I
NSTALLATION
M
OUNTING THE
C
UTTER
B
USHINGS
Rotate the cutter head
until the blade is positioned
in the gap between where the bushings go.
Slide the downstream bushing into position
,
positioning it up to and barely touching the blade (using a
feeler gauge). NOTE: the blade should not be deflected.
Tighten the set screw
against the flat side of the
bushing to hold the bushing in position.
DANGER: Sharp blades!
Always wear cut-resistant gloves when the cut-
ting chamber is open and when handling
blades. Never open cutting chamber without
locking out the cutter power and waiting until
the cutter head stops spinning.
1
2
3
Upstream
Downstream
For more information about
setting and adjusting the gap
for the bushings, see About
Cutter Bushings, in Appendix
C.
Location of set screws
Continued
