![background image](http://html1.mh-extra.com/html/conair/320csc2/320csc2_user-manual_2649055054.webp)
4-12
O
PERATION
CSC Combination Puller/Cutter
UGE048/1103
Raise
will increase the preset by 1.0. The key can be pressed
once for each 1.0 increment required or held down to scroll
up. Releasing the key will freeze the preset at the last value
then press enter.
Lower
will decrease the preset by 1.0. The key can be pressed
once for each 1.0 decrement required or held down to scroll
down. Releasing the key will freeze the preset at the last value
then press enter.
Numeric keys
Key in the time required and press enter. The decimal place is
fixed so remember this when entering the preset. If you
require 750.0 rpm you must key in 7500 and then press enter.
Keying only 750 will set the speed to 075.0 rpm and an error
message with the valid range will be displayed.
Enter or Delete?
If the keyed in number is correct press the enter key for it to
be accepted and return to the Blade Select or Main Mode
Screen. If it is wrong press the delete key and the previous
preset will reappear.
BLADE COUNT SCREEN
By pressing the soft key located under the word Blade or
Count depending on the current mode, the preset for the blade
count is available.
Additional information on how to access
this screen can be found in the operator display overview in
Appendix E of this manual.
The number shown is the current blade count preset, i.e. the
number of blades mounted to the cutter head. A cursor will
appear in the least significant digit. The user has a choice of
ways to adjust this number.
Exit or Prev
, if no change is required press Exit or Prev to
return to the Blade Select or Main Mode Screen.
RUN 1 BLADES
Exit
C
UTTER
C
ONTROL
I
NSTRUCTIONS
B
LADE
C
OUNT
S
CREEN
Continued
C
UTTER
C
ONTROL
I
NSTRUCTIONS
B
LADE
S
PEED
S
CREEN
CONTINUED