T
ESTING THE
I
NSTALLATION
UGE048/1103
CSC Combination Puller/Cutter
I
NSTALLATION
3-17
Turn on the main disconnect.
Plug in the main
power cord and turn on the main disconnect. The display
should fully illuminate and bootup. The amber power on
light illuminates.
Check that the E-Stop button is in the out,
extended position.
NOTE: If the E-Stop button is
pushed in, there will be no power applied to the amplifier
and the operator interface will display “starting com-
mands” for an extended period of time.
Make sure that the Cut On\Off is Off.
If necessary, press button to display off.
Press Start Cutter button.
The light in the button
should light. On CSC cutters, the cutter head will make
one revolution until it finds its home offset position.
Open the knife guard.
The machine start push
button should go out.
If the cutter is not working properly at any time, turn it off
immediately and refer to the Troubleshooting section of this
User Guide.
If you do not encounter any problems, proceed to the
Operation section.
1
2
3
4
5
NOTE
: If “Home Runtime Failed” message is dis-
played. Check for malfunctions of misadjust
ed sensor.