O
PERATION
4-11
UGE048/1103
CSC Combination Puller/Cutter
Raise
will increase the preset by 0.010 second. The key can
be pressed once for each 0.010 second increment required or
held down to scroll up. Releasing the key will freeze the pre-
set at the last value then press enter.
Lower
will decrease the preset by 0.010 second. The key can
be pressed once for each 0.010 seconds decrement required or
held down to scroll down. Releasing the key will freeze the
preset at the last value then press enter.
Numeric keys
Key in the time required and press enter. The decimal place is
fixed so remember this when entering the preset. If you
require 1.000 seconds you must key in 1000 and then press
enter. Keying only 1 will set the time to 0.001 seconds and an
error message will be displayed.
Enter or Delete?
If the keyed in number is correct press the enter key for it to
be accepted and return to the Main End Sense Mode screen. If
it is wrong press the delete key and the previous preset will
reappear.
BLADE SPEED SCREEN
By pressing the soft key located under the word Blade or
Speed depending on the current mode, the preset for that
modes blade speed is available.
Additional information on
how to access this screen can be found in the operator display
overview in Appendix E of this manual.
The number shown is the active modes current blade speed
preset, i.e. the speed the blade will pass through the part. A
cursor will appear in the least significant digit. The user has a
choice of ways to adjust this number.
Exit or Prev
, if no change is required press Exit or Prev to
return to the Blade Select or Main Mode Screen.
C
UTTER
C
ONTROL
I
NSTRUCTIONS
B
LADE
S
PEED
S
CREEN
SPEED 0750.0 rpm
Exit
C
UTTER
C
ONTROL
I
NSTRUCTIONS
H
OLD
-
OFF
S
CREEN
CONTINUED
Continued
