![background image](http://html1.mh-extra.com/html/conair/320csc2/320csc2_user-manual_2649055072.webp)
CSC Combination Puller/Cutter
UGE048/1103
4-30
O
PERATION
P
ROGRAMMING
THE
P
ULLER
S
PEED
Plug in the power cord
to restore power after any
required maintenance.
Turn on the main power.
The cutter control will
bootup. The amber power on light illuminates.
While the cutter is booting up, perform the next three
steps:
Make sure the E-Stop button is in the out,
extended position.
Make sure that the Cut Enable is Off.
If necessary, press button to display off.
Press Start Cutter button.
The light in the button
should light. On CSC Combination Puller/Cutter, the
cutter head will make one revolution until it finds its
home offset position.
Open the knife guard.
The machine start push
button should go out.
If the cutter is not working properly at any time, turn it off
immediately and refer to the Troubleshooting section of this
User Guide.
If you do not encounter any problems, proceed to the
Operation section.
P
OWERING
U
P
NOTE
: You can watch the servo motor amplifier's
status screen during bootup through the
window on the back of the electrical enclo-
sure. This display gives information that
may be useful if you have a problem. See
the Troubleshooting section.
1
2
3
4
5
NOTE:
If “Home Runtime Failed” message is dis-
played. Check for malfunctions of misadjust-
ed sensor.
6
After powering up the combination puller/cutter, you need to
set the puller speed.
Note: For Servo option see separate Appendix F.
Turn the Speed potentiometer CW to increase
or CCW to decrease
.
1