UGE048/1103
CSC Combination Puller/Cutter
O
PERATION
4-35
S
TARTING
THE
P
ULLER
Plug in the power cord
to restore power after any
required maintenance.
Turn on power to the puller.
Plug in the power
cord to restore power after performing any required main-
tenance. Turn the main disconnect to the ON position.
Press the green Start button.
If the puller does not
start, make sure the E-stop button pulled out in the
extended position.
Rotate the speed reference
potentiometer to adjust
belt speed.
Observe the digital line
rate indicator to observe line
speed. (optional)
1
3
4
2
Before you start daily operation
of the puller, you should:
❒
Inspect the puller belts.
❒
Check puller alignment with the extrusion line.
❒
Assure the floor locks are properly engaged.
❒
Thread the extrudate through the sizing equipment,
puller and an other devices on the extrusion line
puller.
See the Maintenance section of this User Guide for detailed
information on daily maintenance procedures.
DANGER: Moving Parts Hazard
Take all necessary precautions when working
around moving parts to prevent body parts and
clothing from being pulled into the machine.
Always disconnect and lock out the main
power source before performing maintenance
on the puller.
Never remove or disable safety devices to
sustain production. Operating without these
devices could lead to hazardous conditions
that can cause severe injury.
5