InteliMains 210 Global Guide
8
contain any kind of security – neither encryption nor authentication. Thus it is intended to be used only in closed
private network infrastructures.
• Avoid exposing the port TCP/502 to the public Internet.
5. SNMP
• The SNMP protocol (port UDP/161) version 1,2 is not encrypted. Thus it is intended to be used only in closed
private network infrastructures.
• Avoid exposing the port UDP/161 to the public Internet.
Used Open Source Software: mBed-TLS
https://www.mbed.com/en/development/software/mbed-tls/
http://www.apache.org/licenses/LICENSE-2.0
1.4 General warnings
1.4.1 Remote control and programing
Controller can be remotely controlled. In the event that maintenance of gen-set has to be done, or controller has
to be programmed, check the following points to ensure that the engine cannot be started or any other parts of
the system cannot be effected.
To be sure:
Disconnect remote control
Disconnect binary outputs
1.4.2 SW and HW versions compatibility
Be aware to use proper combination of SW and HW versions.
1.4.3 Dangerous voltage
In no case touch the terminals for voltage and current measurement!
Always connect grounding terminals!
In any case do not disconnect controller CT terminals!
1.4.4 Adjust the setpoints
All parameters are adjusted to their typical values. However the setpoints has to be checked and adjusted to
their real values before the first starting of the gen-set.
IMPORTANT: Wrong adjustment of setpoints can destroy the gen-set.
Note:
The controller contains a large number of configurable setpoints, because of this it is impossible to
describe all of its functions. Some functions can be changed or have different behavior in different SW versions.
Always check the Global guide and New feature list for SW version which is used in controller. This manual
only describes the product and is not guaranteed to be set for your application.
IMPORTANT: Be aware that the binary outputs can change state during and after software
reprogramming (before the controller is used again ensure that the proper configuration and
setpoint settings are set in the controller).
