InteliMains 210 Global Guide
543
Image 8.162 CM-GPRS module
IMPORTANT: Any manipulation with plug-in module shall be done with disconnected power
supply to controller.
IMPORTANT: CM-4G-GPS and CM-GPRS modules can't be used in one controller in the same time.
Note:
GPRS and CSD services must be provided by your GSM/GPRS operator for successful operation.
Note:
The GPRS and CSD connection should not be used for the firmware update process.
CM-GPRS module works with:
WebSupervisor – internet-based remote monitoring solution
AirGate – powerful connection technology to make internet access as simple as possible
Power consumption
32 mA / 8 VDC
18 mA / 12 VDC
10 mA / 24 VDC
12 mA / 36 VDC
Technical data
SIM card settings
SIM card to be used in CM-4G-GPS or CM-GPRS modules must be adjusted as follows:
SMS service enabled
Packet data (Internet access) enabled (when required for the selected mode of operation)
PIN code security disabled
How to start using CM-GPRS module
You will need a controller, CM-GPRS module, antenna and SIM card with SMS and packet data service.
Make sure that your SIM supports the packet data network type you want to use. I.e. if you want to use the
module in GPRS (2,5G) network you have to confirm with the operator that the particular SIM card does support
2,5G network.
Contact your mobile operator for getting packet data APN (APN = Access Point Name), username and
password.
Example:
APN Name = "internet", UserName = [blank], Password = [blank].
