2-72
Catalyst 2350 Switch Command Reference
OL-19055-01
Chapter 2 Catalyst 2350 Switch Cisco IOS Commands
interface range
Valid values for
port-range
type and interface:
•
vlan
vlan-ID
-
vlan-ID
, where VLAN ID is from 1 to 4094
•
gigabitethernet
module/{
first port
} - {
last port
}, where module is always
0
•
tengigabitethernet
module/{
first port
} - {
last port
}, where module is always
0
For physical interfaces:
–
module is always 0
–
the range is
type
0
/
number
-
number
(for example,
gigabitethernet0/1 - 2
)
•
port-channel
port-channel-number
-
port-channel-number
, where
port-channel-number
is from 1
to 48
Note
When you use the
interface range
command with port channels, the first and last port
channel number in the range must be active port channels.
When you define a range, you must enter a space between the first entry and the hyphen (-):
interface range gigabitethernet0/1 -2
When you define multiple ranges, you must still enter a space after the first entry and before the
comma (,):
interface range gigabitethernet0/1 - 2, gigabitethernet0/1 - 2
You cannot specify both a macro and an interface range in the same command.
You can also specify a single interface in
port-range
. The command is then similar to the
interface
interface-id
global configuration command.
For more information about configuring interface ranges, see the software configuration guide
for this
release.
Examples
This example shows how to use the
interface range
command to enter interface-range configuration
mode to apply commands to two ports:
Switch(config)#
interface range gigabitethernet0/1 - 2
Switch(config-if-range)#
This example shows how to use a port-range macro
macro1
for the same function. The advantage is that
you can reuse
macro1
until you delete it.
Switch(config)#
define interface-range macro1 gigabitethernet0/1 - 2
Switch(config)#
interface range macro macro1
Switch(config-if-range)#
