2-212
Catalyst 2350 Switch Command Reference
OL-19055-01
Chapter 2 Catalyst 2350 Cisco IOS Commands
service-policy
Examples
This example shows how to apply
plcmap1
to an physical ingress port:
Switch(config)#
interface gigabitethernet0/1
Switch(config-if)#
service-policy input plcmap1
This example shows how to remove
plcmap2
from a physical port:
Switch(config)#
interface gigabitethernet0/2
Switch(config-if)#
no
service-policy input plcmap2
This example shows how to apply
plcmap1
to an ingress SVI when VLAN-based QoS is enabled:
Switch(config)#
interface vlan 10
Switch(config-if)#
service-policy input plcmap1
This example shows how to create a hierarchical policy map and attach it to an SVI:
Switch>
enable
Switch#
configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
access-list 101 permit ip any any
Switch(config)#
class-map cm-1
Switch(config-cmap)#
match access 101
Switch(config-cmap)#
exit
Switch(config)#
exit
Switch#
Switch#
config t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
class-map cm-interface-1
Switch(config-cmap)#
match input gigabitethernet0/1 - gigabitethernet0/2
Switch(config-cmap)#
exit
Switch(config)#
policy-map port-plcmap
Switch(config-pmap)#
class-map cm-interface-1
Switch(config-pmap-c)#
police 900000 9000 exc policed-dscp-transmit
Switch(config-pmap-c)#
exit
Switch(config-pmap)#
exit
Switch(config)#
policy-map vlan-plcmap
Switch(config-pmap)#
class-map cm-1
Switch(config-pmap-c)#
set dscp 7
Switch(config-pmap-c)#
service-policy port-plcmap-1
Switch(config-pmap-c)#
exit
Switch(config-pmap)#
class-map cm-2
Switch(config-pmap-c)#
match ip dscp 2
Switch(config-pmap-c)#
service-policy port-plcmap-1
Switch(config-pmap)#
exit
Switch(config-pmap)#
class-map cm-3
Switch(config-pmap-c)#
match ip dscp 3
Switch(config-pmap-c)#
service-policy port-plcmap-2
Switch(config-pmap)#
exit
Switch(config-pmap)#
class-map cm-4
Switch(config-pmap-c)#
trust dscp
Switch(config-pmap)#
exit
Switch(config)#
int vlan 10
Switch(config-if)#
Switch(config-if)#
ser input vlan-plcmap
Switch(config-if)#
exit
Switch(config)#
exit
Switch#
You can verify your settings by entering the
show running-config
privileged EXEC command.
