2-245
Catalyst 2350 Switch Command Reference
OL-19055-01
Chapter 2 Catalyst 2350 Cisco IOS Commands
show controllers ethernet-controller fastethernet
show controllers ethernet-controller fastethernet
Use the
show controllers ethernet-controller fastethernet
privileged EXEC command to display
information about the Ethernet management port, including the port status and the per-interface send and
receive statistics read from the hardware.
show controllers ethernet-controller fastethernet 0
[
phy
[
detail
]] [ |
{
begin
|
exclude
|
include
}
expression
]
Syntax Description
Command Modes
Privileged EXEC (only supported with the
fastethernet 0
keywords in user EXEC mode)
Command History
Usage Guidelines
The output display provides information that might be useful for Cisco technical support representatives
troubleshooting the switch.
Expressions are case sensitive. For example, if you enter
| exclude output
, the lines that contain
output
do not appear, but the lines that contain
Output
appear.
Examples
This is an example of output from the
show controllers ethernet-controller fastethernet 0
command.
See
Table 2-13
and
Table 2-14
for descriptions of the
Transmit
and
Receive
fields.
Switch>
show controller ethernet-controller fastethernet 0
Transmit FastEthernet0 Receive
5925 Bytes 33181 Bytes
0 Unicast frames 78 Unicast frames
15 Multicast frames 437 Multicast frames
1 Broadcast frames 0 Broadcast frames
0 Too old frames 0 Unicast bytes
0 Deferred frames 0 Multicast bytes
0 MTU exceeded frames 0 Broadcast bytes
0 1 collision frames 0 Alignment errors
0 2 collision frames 0 FCS errors
0 3 collision frames 0 Oversize frames
0 4 collision frames 0 Undersize frames
phy
[
detail
]
(Optional) Display the status of the internal registers on the switch physical layer
device (PHY) for the Ethernet management port on the switch.
Use the
detail
keyword to display details about the PHY internal registers.
This display includes the operational state of the automatic medium-dependent
interface crossover (auto-MDIX) feature on an interface.
| begin
(Optional) Display begins with the line that matches the
expression
.
| exclude
(Optional) Display excludes lines that match the
expression
.
| include
(Optional) Display includes lines that match the specified
expression
.
expression
Expression in the output to use as a reference point.
Release
Modification
12.2(46)EY
This command was introduced.